跳至主要内容

Does 2000W car inverter can load kettle to boil water?

I have buy a 2000W inverter. Does it can load kettle to boil water?

1. There is no problem with boiling water. The inverter is plugged into the cigarette lighter or directly connected to the battery, and then converts the 12V or 24V battery voltage to 110V or 220V ac output. As long as the power of the appliance does not exceed the power of the inverter, it can be used normally.

2. But we must also note that due to the use of the car's battery, the battery's loss of electricity is more serious, exacerbating the damage of the battery. In order to charge the battery as quickly as possible, the magneto will work harder and the vehicle will consume more fuel. The increase is related to the degree of your electricity use. Moreover, boiling water is actually equivalent to a large resistor, which generates high heat when the current passes through the resistor. This will cause more damage to the battery. So although it can be used to boil water, try not to do it as often as possible. Such high-resistance and high-power consumer appliances also easily cause the vehicle to burn.

3. Most of the on-board inverters are mainly used to charge equipment and use low-power electricity such as notebooks.

评论

此博客中的热门博文

Why can't most of the modified wave inverters load LED energy-saving lamps?

1.LED belongs to inductive load. The current LED string has a capacitor current limit. The capacitor is charged with about 300 volts DC during charging. This DC voltage and the 300 volts in the inverter are stacked in series to 600 volts. It is easy to put the withstand voltage at only 500-600 volts. Inverter output MOS tube breakdown. 2. Modified sine wave is also divided into two kinds, one is an ordinary, ordinary repair sine wave, just the square wave into a simple correction, one is a good, the other wave is a better correction. High quality repair sine wave with LED lights. Ordinary modified sine wave has many restrictions on the load, such as with resistive load (incandescent lamp, electric furnace (except induction cooker) and other loads) is no problem, but capacitive load (such as rechargeable LED flashlight) will appear on the edge of the pulse Inrush current causes capacitive load to be easily damaged when the modified sine wave power is supplied, and the work of induct...

HOW does an inverter work?

The inverter is a DC to AC transformer, and it is actually a process of conversion is a voltage inverter. AC converter is the voltage of the grid into a stable 12V DC output, while the output of the inverter is the Adapter 12V DC voltage into a high voltage alternating current high frequency; the same two parts are used with more than the width modulation (PWM) technique. Its core is an integrated PWM controller, Adapter using UC3842, the inverter is used TL5001 chip. TL5001 operating voltage range of 3.6 ~ 40V, which features an internal error amplifier, a regulator, oscillators, with dead-controlled PWM generator, low-voltage protection circuit and short circuit protection circuit and so on. Input interface part: There are three signal input section, 12V DC input VIN, work ENB enable voltage and current Panel control signal DIM. VIN provided by the Adapter, ENB voltage provided by the MCU on the motherboard, its value is 0 or 3V, when ENB = 0, the inverter does not work, and ENB = ...